2 five foot Foam Rail cross bars
2 T-clips

An SLP™ or Kit 20 pole is required for each Foam Rail™ cross bar. These poles are not included in the FR2.

No pole is needed if using the Rails with the Side Clamp™ wall mount. These clamps are also not included with the FR2.

The T-Clip is used to mount the poles anywhere along the Rail. Each FR2 comes with 2 T-Clips.

The Foam Rail™ cross bars push the plastic or barrier material against the ceiling but do not hold the material securely in place. You must set up your barrier using the ZipWall® poles placed 8 to 10 feet apart. This makes an incredibly secure and tightly sealed barrier.

Imagine how it would feel to have a contractor run duct tape across your perfect ceiling, or a drive in a row of staples or screws just to create a tight seal with plastic sheeting? With the Foam Rail™ cross bars you'll never have to find out. The Foam Rail™ cross bar works with the SLP™ or Kit 20 poles to create a virtually airtight seal by pushing its foam edge against the plastic and ceiling. Each rail is 5 feet long and is made of strong, lightweight aluminum. The spring loaded pole holds it in place and it takes just seconds to install with out damaging a thing. See it in action, watch the short video demos listed on this page.